Upcom Y Uživatelská příručka stáhnout pdf (Strana 13)

UPCOM TECHNOLOGIES

@BCL@1408FB8F 13

Quick Start Guide

 Check the connectivity of the AC Pins and also at the AC Cable to make sure that

Line or Neutral pins are NOT connected to the ground

 Connect the low power KU Band output from a low power BUC or indoor upconverter to

the labeled port. Nominal input levels are approximately +20 dBm depending on the

output power level of the unit.

 Connect the rigid waveguides to the SSPA’s RF outputs and to the waveguide switch as

indicated in the Redundancy Diagram

 Connect to the “Y” Cable supplied with the units to the “Switch “ Ports at the units and to

the control port of the waveguide switch.

 The SSPA’s output is taken from the waveguide port (RF Out). Caution should be

observed here to make sure that the antenna or a suitable termination is connected to

this port before operating the SSPA.

 Ensure there is proper clearance around the unit.

 Connect the chassis ground (GND) to a proper ground connection

 Connect AC Input power to the connector. The unit will be enabled almost immediately,

provided it is not forced into a mute state.

 Connect the M & C interface to an available COM port on your computer and/or to your

analog based monitoring and control equipment.

 Run the UPCOM TECHNOLOGIES Monitor and Control Program.

 Recommendation: if possible install the SSPA with the fans facing down in order

to avoid accumulation of debris inside the fans that may block the fans.

1 2 ... 8 9 10 11 12 13 14 15 16 17

Žádné komentáře

Upcom Y Uživatelská příručka Strana 13